Double your battery capacity without touching a soldering iron or frying your ESC. This XT60 parallel conversion connector links two identical LiPo battery packs into a single high-current power distribution lead, doubling total mAh capacity while keeping voltage strictly identical. With over 10 years of experience delivering commercial FPV systems across the UK, we know that swapping packs every four minutes gets old fast. Built with heat-resistant nylon XT60 plugs, this plug-and-play adapter keeps your endurance rigs and fixed-wing aircraft airborne without unleashing the magic smoke.
If you fly long-range FPV, heavy-lift platforms, or fixed-wing cruisers, landing to swap 4S packs every few minutes ruins the flow. Instead of risking cold solder joints on homemade parallel harnesses, this adapter gives you a rigid, direct link that keeps wire runs short and resistance low. Connect two matched packs and stay in the air while everyone else is babysitting balance chargers in the pits.
It wires two batteries together in parallel, combining their milliamp-hour (mAh) capacities into one output while keeping the operating voltage identical to a single pack.
No. Connecting packs with different cell counts (e.g., 4S and 6S) or wildly different resting voltages causes violent, uncontrolled current equalization, extreme heat, and an immediate fire hazard. Always connect identical packs at matching charge levels.
Parallel connections demand discipline. Always verify voltage parity with a LiPo checker before plugging in both packs. We provide the hardware, but you provide the common sense.
-50% 
-50% 
-50% 
-50% 
Reviews
There are no reviews yet.