To make it even easier to get your readings, all communication is enacted exclusively via I2C, utilizing our handy Qwiic system so no soldering is required to connect it to the rest of your system. However, we still have broken out 0.1″-spaced pins in case you prefer to use a breadboard.
Each VL53L4CD sensor features a precision to be 1mm with an accuracy around +/-7mm (white target: 88%, indoor, no infrared) and a minimum read distance of this sensor is 1mm. The field of view for this little breakout has a typical full field of view of 18 with a read rate of up to 100Hz. Make sure to power this board appropriately since it will need 2.6V-3.5V to operate. Lastly, please be sure to remove the protective sticker on the VL53L4CD before use otherwise it will, most assuredly, throw off your readings.
Features
Operating Voltage
2.6V to 3.5V
(typically 3.3V via Qwiic cable)
Average Current Consumption
22mA typically
24mA max
40mA peak current (including VSCEL)
Measurement Range: 1mm to 1300mm
Resolution: 1mm
Light Source: Class 1 940nm VCSEL
Field of View: 18
Max Read Rate: 100Hz
2x Qwiic Connectors
7-bit unshifted I 2 C Address: 0x29
Operating Temperature Range
-30C to +85C
Power LED
Jumpers
Pull-up Resistors
LED
Note: The VL53L4CD uses I2C address 0x29 (7-bit) by default. For multiple sensors on one bus, use a Qwiic multiplexer, or control each sensor’s SHUT connection separately and assign unique addresses in software. SHUT is available on the breakout, not the four-wire Qwiic connector.
Note: CLASS 1 LASER PRODUCT CLASSIFIED IEC 60825-1 2014.
-50% 
Reviews
There are no reviews yet.