The RadioMaster RP series receivers are built-in a TCXO (temperature-compensated crystal oscillator) now, which ensures reliable, stable, and accurate signal reception, allowing for superior performance in demanding environments and enhancing the flight experience.
The RP1 andRP22.4GHz ELRS nano series receivers are open-source receivers based on ExpressLRS.The Nano receivers, first developed by Jye Smith from the ExpressLRS development team, feature ESP8285 MCU and SX1280 RF chip. The RP1 has a UFL antenna socket for full-range antenna use. The RP2 has a built-in ceramic antenna which is super light and small in size and ideal for racing.
The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone.
Due to the low-latency and high-refresh-rate RF module, the RP1 and RP2 are ideal for FPV races or Long Range. Suitable for many models due to the ultra-light and Nano size, these receivers can fit just about anywhere!
Compatible with all 2.4GHz ExpressLRS modules and transmitters with built in 2.4GHz ExpressLRS
Specification
Item:RP1NanoExpressLRS2.4ghzReceiver
Type:ISM
MCU:EPS8285
RFChip:SEMTECH SX1281
Telemetry RF power: 10mW
Antenna:65mm2.4ghzTAntenna
FrequencyRange:2.404 – 2.479 Ghz
Maximumreceiverefreshrate:500Hz/F1000Hz
Minimumreceiverrefreshrate:25Hz
Workingvoltage:5v
Weight:2.2g (Includingantenna)
Dimension:13mm*11mm*3mm
FirmwareVersion:ExpressLRSv2.4pre-installed
FWTarget:RadioMasterRP1/22400RX
Businterface:CRSF
TCXO(temperature compensated crystal oscillator)
The TCXO ensures high stability and accuracy in frequency control, compensating for temperature variations. This results in consistent and reliable signal reception, even in extreme temperature conditi
Reviews
There are no reviews yet.
Be the first to review “RadioMaster RP1 V2 ExpressLRS 2.4ghz Nano Receiver” Cancel reply
-50% 
Reviews
There are no reviews yet.