The Olimex ARM-USB-TINY-H Bundle gives you a ready-to-go ARM JTAG debugger kitperfect for flashing or debugging embedded firmware on your drones, AI modules, or MCU boards. It includes the ARM-USB-TINY-H unit itself, the 20-pin to 10-pin adapter, and a USB cable, so you wont need to dig through your parts bin. Its the kind of clean, minimal bundle youre glad to see after losing hours to wiring hell.
Why You Want It
Because juggling SWD vs JTAG adapters at 2 AM is a special kind of suffering. This bundle covers both standard 20-pin JTAG and smaller 10-pin (TC2050 style) targets. The ARM-USB-TINY-H supports 2.05.0 V target voltages, comes with RTCK adaptive JTAG clocking, and gives you solid compatibility with OpenOCD, PlatformIO, and pretty much any ARM toolchain you throw at it. :contentReference[oaicite:1]{index=1}
Specifications
Debugger / Programmer type: ARM JTAG USB (ARM-USB-TINY-H)
Target voltage support: 2.0 V to 5.0 V
Clocking: RTCK adaptive JTAG clock, up to ~30 MHz effective JTAG
Interface: USB 2.0, JTAG 20-pin standard connector
Bundle components:
1 ARM-USB-TINY-H
1 ARM-JTAG-20-10 adapter (20-pin to 10-pin)
1 USB cable (1.8 m)
Board size: 50 40 mm
Compatibility: Works with OpenOCD, PlatformIO, Eclipse GDB, etc.
Whats in the Box*
Olimex ARM-USB-TINY-H debugger
ARM-JTAG 20-to-10 adapter
USB cable
Disclaimer
This bundle provides the hardware for JTAG programming / debugging. Your target board, firmware, and debugging tools are not included.
Still Here?
If youve read this far, you code, you flash, you crash, you repeat. The Olimex ARM-USB-TINY-H Bundle gives you the key to access your ARM MCU internalsflash, debug, dump memorywithout needing half your parts bin. Grab one before your next firmware brick session.
Reviews
There are no reviews yet.
Be the first to review “Olimex ARM-USB-TINY-H Bundle” Cancel reply
-50% 
Reviews
There are no reviews yet.