The T75 is a high performance digital dual redundant power switch with advanced telemetry features and touch switch functionality. It combines a backup battery charging circuit and telemetry with Touch w/LED (Included), optional Sliding, Wireless (R3/RSW) or mechanical switch functionality in a single device.
The T75 is ideal for mid-size models where high-voltage servos are used without voltage stabilization. It provides telemetry and monitors Voltage/V, Capacity/mAh, and Current/A (Dual Rx Batteries, or BEC w/Backup Battery) of both power inputs.
The T75 is suitable for models equipped either with dual receiver batteries or with an ESC battery eliminator circuit (BEC) used as a primary power source, combined with a small backup battery. The device prefers its primary battery input, while in case of voltage drop it automatically switches to the secondary input. The charging circuit may be optionally enabled to charge the secondary backup battery from the primary input/BEC.
If using with R3/RSW Wireless Switch you have to change the setting of the T75 from “Touch” to “Standard” setting. For long-term storage backup battery has to be disconnected due to the constant load of the R3/RSW Wireless Switch.
The T75 is designed to turn ON/OFF the electronics in your model, it can replace a mechanical switch as well. The device remembers its last operating state, and if the battery is accidentally disconnected, the T75 will automatically boot up again as soon as the battery is connected again.
Specifications and Features
- Intelligent dual battery backer/multiplexer with configurable voltage switchover threshold.
- Touch switch function (Included), Optional Mechanical, Sliding or Wireless (R3/RSW).
- Jeti Duplex EX, Futaba S.Bus2, Multiplex MSB, Graupner Hott, PowerBox telemetry support.
- Optional charging of the secondary/backup battery with capacity protection limits.
- Remembers the last operating state if the battery is accidentally disconnected.
- Two telemetry expansion ports that allow connecting additional Duplex EX/EX Bus sensors.
Continues/Peak Current:20A/40A (Continues/2 Seconds)
Operational Voltage:4-12.6V (Recommended 5-8.4V)
Supported Systems:Jeti EX, Multiplex M-LINK, Graupner HoTT, Futaba S.Bus/S.Bus2, PowerBox
Dimensions:
-20% 
Reviews
There are no reviews yet.